Ethernet channel bonding driver v3.4.0-1

 · Dec 25 l3-core-hrk1 kernel: Ethernet Channel Bonding Driver: v (October 7, ) Dec 25 l3-core-hrk1 kernel: bonding: MII link monitoring set to 80 ms Dec 25 l3-core-hrk1 kernel: q: adding VLAN 0 to HW filter on device bond0 Dec 25 l3-core-hrk1 kernel: ADDRCONF(NETDEV_UP): bond0: link is not ready. The following command show that each interface is in a different aggregate ID which means that they haven't successful negotiate with the network switch: # cat /proc/net/bonding/bond0 Ethernet Channel Bonding Driver: v (Ap) Bonding Mode: IEEE ad Dynamic link aggregation Aggregator selection policy (ad.  · Ethernet Channel Bonding Driver: v (October 7, ) Bonding Mode: IEEE ad Dynamic link aggregation Transmit Hash Policy: layer2 (0)Estimated Reading Time: 2 mins.

Ethernet Channel Bonding Driver: v (October 7, ) Bonding Mode: IEEE ad Dynamic link aggregation Transmit Hash Policy: layer2 (0). # cat /proc/net/bonding/bond0 Ethernet Channel Bonding Driver: v (October 7, ) Bonding Mode: fault-tolerance (active-backup) Primary Slave: None Currently Active Slave: eth4 0 Down Delay (ms): 0 Slave Interface: eth0 MII Status: up 1. Why do we not have same mac address for interface eth8 in the output of ifconfig and /proc/net/bonding/bond0? [root@example ~]# cat /proc/net/bonding/bond0 Ethernet Channel Bonding Driver: v (October 7, ) Bonding Mode: load balancing (round-robin) MII Status: up MII Polling Interval (ms): 0 Up Delay (ms): 0 Down Delay (ms): 0 Slave Interface: eth0 MII Status: up Speed: Mbps.

२०११ डिसेम्बर २५ The version of igb driver was changed from 2.x to 3.x. l3-core-hrk1 kernel: Ethernet Channel Bonding Driver: v (October 7, ). Ethernet Channel Bonding Driver: v (October 7, ) Bonding Mode: fault-tolerance (active-backup) Primary Slave: None. २०१२ जनवरी १० Broadcom Corporation NetXtreme II BCM Gigabit Ethernet. DEVICE=bond0 Ethernet Channel Bonding Driver: v (October 7, ).